2018 Ford Focus ST 2.0L Turbo 4-Cylinder Gauge Setup
Flock 52mm Gauge
One gauge for OBD-II data and wired sensors. Choose your setup below.
This setup covers the US-market 2018 Ford Focus ST with the 2.0L Turbo 4-Cylinder engine. Use one Flock 52mm Gauge for your selected OBD-II readings and wired-sensor measurements.
Choose the correct powertrain
- Model years
- 2018
- Engine
- 2.0L Turbo 4-Cylinder
- Listed transmission choices
- Manual 6-spd
- Listed drive configurations
- Front-Wheel Drive
For a Focus ST or RS used on a spirited drive, intake temperature and engine cooling are useful companions to RPM.
What to monitor on this engine
Coolant temperature and RPM are practical first readings for this engine. Add intake-air temperature for a view of intake heat under repeated load. If you display pressure, keep absolute manifold pressure distinct from boost relative to atmosphere.
Installation approach
Locate the gauge near the factory instruments while keeping the display and cable away from the manual shifter’s full travel. Fit the mount from your normal seating position before fixing it in place.
Connect the OBD-II adapter at the vehicle diagnostic connector and secure its cable along fixed trim. Leave the connector accessible for servicing. Follow the Flock user manual for gauge power, adapter setup and wired-sensor connections.
Custom PID settings
These OBDb definitions fit the current Flock firmware. Enter the request, CAN header, formula and unit shown below in the gauge’s custom-PID settings.
Oil pressure
- Request:
220415 - CAN header:
7E0 - Formula:
(A-256*floor(A/128))*256+B - Unit: kPa
Configure your gauge
The gauge displays whole-number OBD readings. For temperature definitions labeled C, use the gauge’s temperature preference to choose Celsius or Fahrenheit.
Browse all gauge setup guides · Model installation guide
Sources
Signal definitions are adapted from OBDb contributors under CC BY-SA 4.0. Adaptations include Flock-compatible formulas and unit labels.
Get your Flock Gauge
Choose the Flock 52mm Gauge with the OBD-II option for this setup.