OBDII Debugging

So sorry you are experience issues with the OBDII adapter and your gauge.

Here are the instructions for installing a firmware which will allow you to pull logs from your gauge so I can diagnose what is going on.

Download for OBDII debugging firmware

Steps for Install and pulling the data: 

  1. Unplug and Plug the OBDII adapater to get the gauge to fully power cycle,
  2. When the gauge says "Connecting to OBDII" tap one of the buttons and make sure you hear a beep, this will boot the gauge even without connecting to OBDII
  3. Press and hold one of the buttons to put it into settings mode
  4. Connect to the gauge's wifi and scan the QR code once your phone is connected to the wifi
  5. Tap the settings icon on the top right of the settings screen and upload the firmware from here
  6. The gauge will restart and install the firmware.
  7. Cycle the power one more time
  8. when the gauge says "Connecting to OBDII" tap one of the buttons and make sure you hear a beep
  9. Once the gauge boots up tap and hold one of the buttons to enter into settings mode
  10. You should see "OBDII-TEST-2" below the "Settings Mode Connect to wifi" message to confirm that the new firmware is loaded
  11. Connect to the wifi
  12. Navigate to 192.168.4.1/obdii to download the OBDII logs
  13. Email those to hello@flock-mfg.com and I will respond to you quickly with a resolution

I want to make sure everyone is happy with their gauge. I understand that this product is new and has some rough edges that I'm working out. If you are not happy with the gauge or want to return the gauge please DM me on IG or email me at hello@flock-mfg.com and I'll get everything sorted out for you.